8mm SER 59M 2 Flute Ti-Namite A Carbide Endmill #43953 20x90 PRY5030 23 Hollow punches :

23 Hollow punches :

3 styles of holders: R-8

the centre of the bar is then obtained when the pointer lines up with the line on the short shaft

36 keyway combinations

Helps to eliminate cam-out and promotes fastener retention

8mm SER 59M 2 Flute Ti-Namite A Carbide Endmill #43953 20x90 PRY5030 23 Hollow punches :SGS 8mm Ser 59M 2Fl Ti Namite A Carbide Endmill 2 Flute End Mills Square End Micrograin Solid Carbide 30 Right Hand Spiral Right Hand Cutting Center Cutting. Ti Namite A Coated Aluminum Titanium Nitride (AlTiN) The most abrasion resistant and hardest coating, Ti NAMITE A is preferred for high speed and dry cutting and recommended for the machining of cast iron, hardened tool steels up to HRc 60 and other heat resistant alloys. Recommended for